NEC EX241UN-H-BK Users Manual - Page 8

4. Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connector to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the computer (Figure C.1a). If using the cord from a USB device, plug into the downstream port of the monitor. 5. When using an optional sensor, connect the stereo micro plug cable to the SENSOR (Figure C.1). NOTE: Incorrect cable connections may cause abnormal operation, damage display quality/components of LCD module and/ or shorten the module's life. NOTE: Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor turns down the sound. NOTE: Adjustment of the volume control as well as the equalizer to other settings than the center position may increase the ear-/headphones output voltage and therefore the sound pressure level. 30° Tilt A Type A Type Highest Stand Position Headphone USB 3.0 Downstream USB 3.0 Upstream SENSOR B Type B Type ControlSync IN/OUT*1 DisplayPort IN/OUT*2 DVI HDMI D-SUB Audio Input Figure C.1a Power cord *1: See page 11. *2: See page 13. Figure C.1 Figure C.2 6. Place the cable holder onto the stand (Figure C.2). Place the cables in the cable holder firmly and evenly (Figure C.3 and Figure C.4). 7. Please check that you can still rotate, raise and lower the monitor screen after you have installed the cables. Power Cord DVI Cable Figure C.3 *3: ø 3.5 stereo mini plug. HDMI Cable DisplayPort Cables Mini D-SUB 15 pin Cable ControlSync Cables Audio Cable*3 Power Cord DVI Cable Figure C.4 HDMI Cable DisplayPort Cables Mini D-SUB 15 pin Cable ControlSync Cables Audio Cable*3 8. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet. NOTE: Please refer to Caution section of this manual for proper selection of AC power cord. English-6