NEC LCD2080UXI-BK MultiSync LCD2080UXi User's Manual - Page 39
Swivel, Remove Monitor Stand for Mounting
UPC - 805736013719
View all NEC LCD2080UXI-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Tilt Grasp top and bottom sides of the monitor screen with your hands and adjust the tilt as desired (Figure TS.1). Swivel Grasp both sides of the monitor screen with your hands and adjust the swivel as desired (Figure TS.2). NOTE: Figure TS.1 Handle with care when tilting the monitor screen. Figure TS.2 Remove Monitor Stand for Mounting To prepare the monitor for alternate mounting purposes: 1. Disconnect all cables. 2. Place hands on each side of the monitor and lift up to the highest position. 3. Place monitor face down on a non-abrasive surface. (Place the screen on a 25 mm platform so that the stand is parallel with the surface) (Figure S.1). 25 mm Figure S.1 4. Remove the two top screws connecting the monitor to the stand (Figure S.2). Turn the stand to 180° counterclockwise (you will hear two clicks). Remove the screws from the bottom (Figure S.3) and lift off the stand. The monitor is now ready for mounting in an alternate manner. 5. Reverse this process to reattach stand: tighten the two bottom screws, turn stand 180° counter clockwise (you will hear two clicks), and tighten two top screws. NOTE: Use only VESA-compatible alternative mounting method (100 mm pitch). NOTE: Handle with care when removing monitor stand. Figure S.2 Figure S.3 Caution: Use the original screws (4 pcs) when mounting to avoid damage to the monitor and stand. To fulfil the safety requirements the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark). English-6 1-39