NEC X554HB Users Manual - Page 27

English TILE MATRIX Allows one image to be expanded and displayed over multiple screens (up to 100) through a distribution amplifier. NOTE: Low resolution is not suitable for tiling to a large number of monitors. You can operate without a distribution amplifier at a lower number of screens. NOTE: This function is released when selecting IMAGE FLIP except for NONE. Dynamic or Zoom will not work when Tile Matrix is activated. When "DYNAMIC" or "ZOOM" is selected in ASPECT while executing TILE MATRIX, the setting will be applied after completing of TILE MATRIX. H MONITORS Number of monitors arranged horizontally. 1 V MONITORS Number of monitors arranged vertically. 1 POSITION Select which section of the tiled image to be displayed on the monitor. 1 TILE COMP Turns the TILE COMP feature on. NO TILE MATRIX ENABLE Enables Tile Matrix. NO FRAME COMP (not adjustable) V SCAN REVERSE (not adjustable) TILE MATRIX MEM When "INPUT" is selected, TILE MATRIX setting is applied to each signal input. COMMON AUTO TILE MATRIX SETUP Allows auto setting of multiple screens by inputting the number of monitors arranged horizontally and vertically on the primary monitor. Following settings are set automatically: MONITOR ID, TILE MATRIX, TILE MATRIX MEM, Input Signal, VIDEO OUT SETTING, DisplayPort in TERMINAL SETTING. NOTE: All monitors which follow in the chain with LAN should be ON. When executing this function while in standby mode or power save mode, "LAN POWER" should be set to ON. AUTO ID will be automatically executed. When you use this function, it is recommended that monitors are chained by DisplayPort cable. Example of installation via LAN: H MONITORS 3 V MONITORS 3 Primary monitor DEACTIVATE POWER ON DELAY DELAY TIME LINK TO ID VIDEO OUT SETTING POWER INDICATOR SETTING COPY COPY START ALL INPUT RESET Adjusts the delay time between being in "standby" mode and entering "power on" mode. "POWER ON DELAY" can be set between 0 and 50 seconds. When "ON" selected, delay time is linked with Monitor ID. It takes more time as larger ID number. Enables the signal output from DPORT. See also page 27 "DisplayPort" in TERMINAL SETTING. NOTE: When VGA or Y/Pb/Pr is selected as the main picture, nothing will be output from DPORT. When this function is ON, DPORT cannot be selected as the sub picture. When this function is ON, INPUT CHANGE is limited to be NORMAL or QUICK. When this function is ON and DPORT is selected as the main picture, PIP CHANGE button of remote control (see page 11) is disabled. Turns ON or OFF the LED located at the front of the monitor. If "OFF" is selected, LED will not light when the LCD monitor is in active mode. In a daisy chain scenario, select the OSD menu categories that you want to copy over to the other monitor. NOTE: When you use this function, monitors should be daisy chained by LAN. This function resets to default when power is off. This function has a limit depending on the cable you use. Select "YES" and press the SET button to start copying. All input terminals settings are copied when you select this item. Default is off. Resets "MULTI DISPLAY" options back to factory settings except for POWER ON DELAY and VIDEO OUT SETTING. 0 SEC. OFF ON ON NO - English-25