NaceCare PT 30 PT 30 Owners Manual - Page 12

Step A - Solution Spraying And Chemical Action

Get NaceCare PT 30 PDF manuals and user guides View all NaceCare PT 30 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Preparation for work To prepare the machine for work, do the following operations: 1. Insert the male quick disconnect coupling (located at the end of the spray/rinse pipe) into the female quick disconnect coupling (located on the regulation panel). 2. Connect the spray/rinse accessory to the solution/rinse hose. 3. Put some fresh water into the solution tank. Put only water, without chemical. Use clean buckets only. In fact, the water put in the tank will be used later also for rinsing. 4. Verify that the chemical tank is well connected to the input of the detergent on the regulation panel and that it is not empty. NOTE: The machine was studied to work correctly with the products SANI-CLEAN, SUPER-CLEAN and ACID-CLEAN. We cannot grant the correct working of the machine with different products. 5. Connect the plug of the machine to a proper electrical socket, provided of grounding. Read carefully the indications in the safety regulation paragraph. Working method The cleaning process is carried out through 3 steps: A. Solution spraying and chemical action, B. Rinsing and finishing, C. Vacuuming the residual of liquid. STEP A - SOLUTION SPRAYING AND CHEMICAL ACTION 1. Switch on the solution pump, by acting on the pump switch, located on the control panel. 2. Turn the "solution/rinse" lever in the "solution" position, to allow picking up the chemical. During solution spraying, the chemical is automatically dosed with a concentration of about 7%. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
12
Preparation for work
To prepare the machine for work, do the following operations:
1. Insert the male quick disconnect coupling (located at the end of the spray/rinse pipe) into
the female quick disconnect coupling (located on the regulation panel).
2. Connect the spray/rinse accessory to the solution/rinse hose.
3. Put some fresh water into the solution tank. Put only water, without chemical. Use clean
buckets only. In fact, the water put in the tank will be used later also for rinsing.
4. Verify that the chemical tank is well connected to the input of the detergent on the
regulation panel and that it is not empty.
NOTE: The machine was studied to work correctly with the products SANI-CLEAN,
SUPER-CLEAN and ACID-CLEAN. We cannot grant the correct working of the
machine with different products.
5. Connect the plug of the machine to a proper electrical socket, provided of grounding.
Read carefully the indications in the safety regulation paragraph.
Working method
The cleaning process is carried out through 3 steps:
A. Solution spraying and chemical action,
B. Rinsing and finishing,
C. Vacuuming the residual of liquid.
STEP A – SOLUTION SPRAYING AND CHEMICAL ACTION
1. Switch on the solution pump, by acting on the pump switch, located on the control panel.
2. Turn the “solution/rinse” lever in the “solution” position, to allow picking up the chemical.
During solution spraying, the chemical is automatically dosed with a concentration of
about 7%.