NaceCare PT 30 PT 30 Owners Manual - Page 14

Step C - Vacuuming The Residual Liquid From Hard Floor

Get NaceCare PT 30 PDF manuals and user guides View all NaceCare PT 30 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

STEP C - VACUUMING THE RESIDUAL LIQUID FROM HARD FLOOR After completing the cleaning of the vertical surfaces, the sanitary fixtures and all the surfaces to be cleaned, it is possible to vacuum the residual liquid from hard floor. This operation is particularly useful in case there are not drain hole on hard floor in the nearby. To vacuum the liquid, proceed as follows: 1. Connect the machine to the floor tool, using the vacuum hose. 2. Switch on the vacuum motor. NOTE: The capacity of the recovery tank is enough to vacuum all the liquid previously sprayed with a full tank of the clean water tank. After vacuuming the residual liquid, do not re-fill the clean water tank before draining the recovery tank. Furthermore, avoid to vacuum liquid not sprayed by the same machine, but for example by other sources. In this case in fact the quantity of water vacuumed into the recovery tank could be excessive for its capacity. If this should happen, check often the level of the recovery tank. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
14
STEP C – VACUUMING THE RESIDUAL LIQUID FROM HARD FLOOR
After completing the cleaning of the vertical surfaces, the sanitary fixtures and all the
surfaces to be cleaned, it is possible to vacuum the residual liquid from hard floor.
This operation is particularly useful in case there are not drain hole on hard floor in the
nearby.
To vacuum the liquid, proceed as follows:
1. Connect the machine to the floor tool, using the vacuum hose.
2. Switch on the vacuum motor.
NOTE:
The capacity of the recovery tank is enough to vacuum all the liquid previously
sprayed with a full tank of the clean water tank. After vacuuming the residual liquid, do not
re-fill the clean water tank before draining the recovery tank. Furthermore, avoid to vacuum
liquid not sprayed by the same machine, but for example by other sources. In this case in
fact the quantity of water vacuumed into the recovery tank could be excessive for its
capacity. If this should happen, check often the level of the recovery tank.