Netgear FS728TPv2 FS728TPv2 Hardware Installation Guide - Page 11

FS728TP Hardware Installation Guide LED Designations Port LEDs The following table describes the RJ-45 and SFP port LED designations. There are two LEDs for each RJ-45 port. Each SFP port has its own indication LED. LED Designation Link/Speed/ACT LED mode for port 1 to 24: • Per port: - Solid Green - A valid 100 Mbps link is established. - Blinking Green - Packets transmitting/ receiving is occurring at 100 Mbps. - Blinking Yellow - A valid 10 Mbps link is established. - Flashing Yellow - No link is established. PoE LED mode for port 1 to 24: • Per port: - Off - No PoE powered device (PD) is connected. - Solid Green - The PoE powered device (PD) is connected and the port is supplying power. - Solid Yellow - Indicates one of the following failures caused the device not delivering power to that port: • Indicates one of the following failures caused the device not delivering power to that port: • PD power demand exceeds the available power • PoE current exceeds PD's classification • Out of proper voltage band (44 VDC-57 VDC for IEEE 802.3af) Port Speed/Link/ACT LED for SFP • Off - No link ports (port 25 to 26): • Solid Green - A valid 1000 Mbps link is established. • Blinking Green - Packets transmitting/receiving is occurring at 1000 Mbps. • Solid Yellow - A valid 100 Mbps link is established. • Blinking Yellow - Packets transmitting/receiving is occurring at 100 Mbps. RJ-45 jacks with LEDs for the four 10/100/1000 copper ports (port 25 to 28): • Right LED (Link/ACT LED): - Off - No link is established - Solid Green - A valid link is established. - Blinking Green - Packets transmitting/receiving is occurring. • Left LED (Speed LED): - Off - Either 10 Mbps link is established or no link established. - Solid Green - A valid 1000 Mbps link is established. - Blinking Green - A valid 100 Mbps link is established. Chapter 2: Physical Description | 11