Netgear FS752TPS FS752TS Hardware manual - Page 25
LED Designations, Port LEDs
View all Netgear FS752TPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
FS700TS Hardware Installation Guide Figure 3-6 illustrates the NETGEAR FS752TPS Smart Switch back panel: Figure 3-6 The back panel contains the following: • A 100-240VAC/50-60 Hz universal input, which is a standard AC power receptacle for accommodating the supplied power cord. LED Designations This section provides an explanation for the following LED types: • "Port LEDs" • "System LEDs" Port LEDs The following table describes the port LED designations. Table 3-1. Port LEDS - Non-LED Devices Port 24/48-10/100M Ports One LED/Port LED Link/ACT/SPD LED Designation • Off - No 10/100Mbps link is established on the port. • Solid Green - A valid 100Mbps link is established on the port. • Flashing Green - Packet transmission or reception is occurring on the port at 100Mbps. • Solid Yellow - A valid 10Mbps link is established on the port. • Flashing Yellow - Packet transmission or reception is occurring on the port at 10Mbps. Physical Description v1.0, September 2007 3-22