Netgear FSM7226RS FSM7226RS / FSM7250RS Hardware Installation Guide - Page 25

Managed Layer 2+ Stackable Switches FSM7226RS and FSM7250RS Hardware Installation Guide 1. Connect the null-modem cable to the console port on the rear of the switch. Console port Figure 2-5 2. Connect the other end of the cable to a workstation or terminal. 3. If you attached a workstation, start a terminal-emulation program. • Microsoft Windows users can use HyperTerminal, which comes with the Windows operating systems. • Macintosh users can use ZTerm. • UNIX users can use a terminal emulator such as TIP. 4. Configure the terminal-emulation program to use the following settings: • Baud rate: 9,600 bps • Data bits: 8 • Parity: none • Stop bit: 1 • Flow control: none After you connect a console to the switch, you will need to configure the switch. The following documents are provided for this purpose: • Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches: Gives detailed examples of how to use the CLI, and is located on the Resource CD. • NETGEAR 7000 Series Managed Switch Administration Guide: Describes configuration tasks, and is located on the Resource CD. Hardware Installation 2-9 v1.0, October 2008