Netgear GSM7224 GSM7224 User Manual - Page 36
Quick Startup IP Address, Table 6-4., Quick Startup User Account Management - default ip
![]() |
UPC - 606449069150
View all Netgear GSM7224 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Table 6-3. Quick Startup User Account Management Command Details show loginsession config users passwd save config logout Displays all of the login session information Allows the user to set passwords or change passwords needed to log in. A prompt appears requesting the users old password. In the absence of an old password leave the area blank. The operator must press enter to execute the command. The system then prompts the user for a new password then a prompt to confirm the new password. If the new password and the confirmed password match a message is displayed. This command saves passwords and all other changes to the device. If you do not issue this command, all configurations will be lost when a power cycle is performed on the switch or when the switch is reset. Logs the user out of the switch Quick Startup IP Address To view the network parameters the operator can access the device by the following three methods. • Simple Network Management Protocol - SNMP • Telnet • Web browser Note: Helpful Hint - do a save config after changing the network parameters so that the configurations are not lost. Table 6-4. Quick Startup IP Address Command Details show network Displays the Network Configurations IP Address - IP Address of the interface Default IP is 0.0.0.0 Subnet Mask - IP Subnet Mask for the interface Default is 0.0.0.0 6-4 Quick Startup 202-10010-01
![](/manual_guide/products/netgear-gsm7224-gsm7224-user-manual-e21ada3/36.png)