Netgear GSM7248R CLI Reference Manual - for 7200RS Series Layer-2 Stackable Sw - Page 229
match ip dscp, match ip precedence
View all Netgear GSM7248R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches To specify the match condition as a single keyword, the value for is one of the supported port name keywords. The currently supported values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number. To specify the match condition using a numeric notation, one layer 4 port number is required. The port number is an integer from 0 to 65535. Format matchdstl4port {portkey | } Mode Class-Map Config 13.3.10 match ip dscp This command adds to the specified class definition a match condition based on the value of the IP DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order six bits of the Service Type octet in the IP header (the low-order two bits are not checked). The value is specified as either an integer from 0 to 63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef. Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Format Mode match ip dscp Class-Map Config 13.3.11 match ip precedence This command adds to the specified class definition a match condition based on the value of the IP Precedence field in a packet, which is defined as the high-order three bits of the Service Type octet in the IP header (the low-order five bits are not checked). The precedence value is an integer from 0 to 7. Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a match criterion for the same Service Type field in the IP header, but with a slightly different user notation. Format Mode match ip precedence Class-Map Config Quality of Service (QoS) Commands v1.0, October 2008 13-13