Netgear M4100-24G-POE Hardware Installation Guide - Page 23

ProSafe M4100 and M7100 Managed Switches Software Administration Manual - prosafe + manual

Get Netgear M4100-24G-POE PDF manuals and user guides View all Netgear M4100-24G-POE manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

NETGEAR Managed Switch 3. Connect the other end of the cable to a workstation or terminal. 4. If you attached a workstation, start a terminal emulation program. • Microsoft Windows users can use HyperTerminal if it comes with the Windows operating system. If it does not, you need to install another third-party terminal emulator such as Tera Term. • Macintosh users can use ZTerm. • UNIX users can use a terminal-emulator such as TIP. 5. Configure the terminal emulation program to use the following settings: • Baud rate: 115,200 bps • Data bits: 8 • Parity: none • Stop bit: 1 • Flow control: none After you connect a console to the switch, you need to configure it. The following documents are provided for this purpose: • Quick Installation Guide: Explains basic setup and configuration (provided as both a print document and in PDF format on the Resource CD). • ProSafe Managed Switch Command-Line Interface (CLI) User Manual: Gives detailed examples of how to use the CLI. • ProSafe M4100 and M7100 Managed Switches Software Administration Manual: Describes configuration tasks. Hardware Installation 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
Hardware Installation
23
NETGEAR Managed Switch
3.
Connect the other end of the cable to a workstation or terminal.
4.
If you attached a workstation, start a terminal emulation program.
•
Microsoft Windows users can use HyperTerminal if it comes with the Windows
operating system. If it does not, you need to install another third-party terminal
emulator such as Tera Term.
•
Macintosh users can use ZTerm.
•
UNIX users can use a terminal-emulator such as TIP.
5.
Configure the terminal emulation program to use the following settings:
•
Baud rate: 115,200 bps
•
Data bits: 8
•
Parity: none
•
Stop bit: 1
•
Flow control: none
After you connect a console to the switch, you need to configure it. The following documents
are provided for this purpose:
•
Quick Installation Guide:
Explains basic setup and configuration (provided as both a print
document and in PDF format on the Resource CD).
•
ProSafe Managed Switch Command-Line Interface (CLI) User Manual:
Gives detailed
examples of how to use the CLI.
•
ProSafe M4100 and M7100 Managed Switches Software Administration Manual
:
Describes configuration tasks.