Netgear M4100-D12G CLI Manual - Page 26

ProSafe M4100 and M7100 Managed Switches Term Interface Type Admin Mode Physical Mode Physical Status Link Status Link Trap LACP Mode Definition Valid slot and port number separated by forward slashes. If not blank, this field indicates that this port is a special type of port. The possible values are: • Mirror - this port is a monitoring port. For more information, see Port Mirroring on page 121. • PC Mbr- this port is a member of a port-channel (LAG). • Probe - this port is a probe port. The Port control administration state. The port must be enabled in order for it to be allowed into the network. - May be enabled or disabled. The factory default is enabled. The desired port speed and duplex mode. If autonegotiation support is selected, the duplex mode and speed is set from the auto-negotiation process. Note that the maximum capability of the port (full-duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and transmission rate. The factory default is Auto. The port speed and duplex mode. The Link is up or down. This object determines whether to send a trap when link status changes. The factory default is enabled. LACP is enabled or disabled on this port. show port protocol This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group. Format Mode show port protocol { | all} Privileged EXEC Term Group Name Group ID Protocol(s) VLAN Interface(s) Definition The group name of an entry in the Protocol-based VLAN table. The group identifier of the protocol group. The type of protocol(s) for this group. The VLAN associated with this Protocol Group. Lists the slot/port interface(s) that are associated with this Protocol Group. Switching Commands 26