Netgear M4100-D12G CLI Manual - Page 424
IPv6 PIM Commands, ipv6 pim denseGlobal Config, ipv6 pim Interface Config
View all Netgear M4100-D12G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 424 highlights
ProSafe M4100 and M7100 Managed Switches If you use the summary parameter, the command displays the following column headings in the output table: Term Source IP Group IP Protocol Incoming Interface Outgoing Interface List Definition The IP address of the multicast data source. The IP address of the destination of the multicast packet. The multicast routing protocol by which this entry was created. The interface on which the packet for this source arrives. The list of outgoing interfaces on which this packet is forwarded. IPv6 PIM Commands This section describes the Protocol Independent Multicast (PIM) commands that support the PIM version of IPv6. ipv6 pim dense(Global Config) Use this command to administratively enable PIM-DM Multicast Routing Mode across the router (Global Config). Default Format Mode disabled ipv6 pim dense • Global Config • Interface Config no ipv6 pim dense (Global Config) Use this command to administratively disable PIM-DM Multicast Routing Mode either across the router (Global Config) or on a particular router (Interface Config). Format Mode no ipv6 pim dense Global Config ipv6 pim (Interface Config) Use this command to set the administrative mode of PIM on an interface to enabled. Default Format Mode disabled ipv6 pim Interface Config IPv6 Multicast Commands 424