Netgear M5300-52G3 Software Administration Manual - Page 133

ProSafe Managed Switch 4. Apply the ACL to one or more interfaces. Set Up an IP ACL with Two Rules This section shows you how to set up an IP ACL with two rules, one applicable to TCP traffic and one to UDP traffic. The content of the two rules is the same. TCP and UDP packets will be accepted by the 7000 Series Managed Switch only if the source and destination stations have IP addresses within the defined sets. Layer 3 switch TCP packet to 192.178.88.3 rejected. Dest. IP not in range. Layer 2 switch TCP packet to 192.178.77.3 accepted. Dest. IP in range. Port 1/0/2 ACL 1 192.168.77.1 192.168.77.4 192.168.77.9 192.168.77.2 Figure 16. IP ACL with rules for TCP rraffic and UDP rraffic CLI: Set Up an IP ACL with Two Rules The following is an example of configuring ACL support on a 7000 Series Managed Switch. Create ACL 101. Define the first rule: The ACL will permit packets that match the specified source IP address (after the mask has been applied), that are carrying TCP traffic, and that are sent to the specified destination IP address. 1. Enter these commands: (Netgear Switch) #config (Netgear Switch) (Config)#access-list 101 permit tcp 192.168.77.0 0.0.0.255 192.178.77.0 0.0.0.255 Chapter 10. ACLs | 133