Netgear M5300-52G3 Software Administration Manual - Page 264

ProSafe Managed Switch Create a Static Address The example is shown as CLI commands and as a Web interface procedure. CLI: Create a Static Address (Netgear Switch) (Interface 1/0/1)#port-security mac-address 00:13:00:01:02:03 Web Interface: Create a Static Address 1. Select Security > Traffic Control > Port Security > Static MAC address. A screen similar to the following displays. 2. Under Port List, in the Interface list, select 1/0/1. 3. In the Static MAC Address section of the screen, enter the following information: • In the Static MAC Address field, enter 00:13:00:01:02:03. • In the Vlan ID list, select 3. 4. Click Add. Protected Ports This section describes how to set up protected ports on the switch. Some situations might require that traffic is prevented from being forwarded between any ports at Layer 2 so that one user cannot see the traffic of another user on the same switch. Protected ports can: • Prevent traffic from being forwarded between protected ports. • Allow traffic to be forwarded between a protected port and a non-protected port. 264 | Chapter 15. Security Management