Netgear ME101 ME101 User Manual - Page 10
Installing the Configuration Utility - wireless bridge
UPC - 606449026634
View all Netgear ME101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installing the Configuration Utility To configure the bridge you use the configuration utility on the included Resource CD. Note: To run the configuration utility, you must have the bridge connected using the provided Ethernet crossover cable to a computer running Windows 98 or 98SE, Me, 2000, or XP - directly or through a hub. If you have a Macintosh® computer, use the browser-based configuration procedure on page 12. 1. Insert the Resource CD in a networked computer's CD-ROM drive. The NETGEAR software installation utility should start up automatically. 2. Click Install Utility. 3. Follow the instructions on screen to install the ME101 Configuration Utility. 4. Click Finish. 5. Restart the computer. 6. If you had the bridge connected to another device, you must connect it to the computer where you installed the Configuration Utility. Note: If the bridge and the computer are connected to the same hub, you don't need to directly connect them. a. If you had the bridge powered up, unplug it. b. Connect the provided Ethernet crossover cable between the computer and the bridge. c. Plug the power adapter into the bridge and then plug the power adapter into a power source. Default Ethernet DC in 5V Antenna ME101 Wireless Ethernet Bridge 8