Netgear WAB102 WAB102 User Manual - Page 16

User's Guide for the WAB102 802.11a+b Dual Band Wireless Access Point Default Factory Settings When you first receive your WAB102, the default factory settings will automatically be set, as shown below. You can restore these defaults with the Factory Default Restore switch on the rear panel - see "WAB102 Wireless Access Point Rear Panel" on page 7. After you install the WAB102 dual band AP, you may customize any of the settings to better meet your networking needs - see the following section, "Basic Configuration" on page 14. FEATURE User Name Password Access Point Name AP IP Address AP Subnet Mask SSID for both 802.11a & 802.11b 11a RF Channel 11b RF Channel WEP Authentication Type DEFAULT FACTORY SETTINGS admin 1234 netgearxxxxxx where xxxxxx are the last six digits of the AP's MAC address 192.168.0.226 255.255.255.0 Wireless 52 Non-Turbo Mode; 50 Turbo Mode 6 Disabled Open System Setting Up Basic Wireless Connectivity 13