Netgear WAB102 WAB102 User Manual - Page 6
System Requirements, WAB501 Dual Band Wireless Adapter. - power adapter
UPC - 606449025231
View all Netgear WAB102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
User's Guide for the WAB102 802.11a+b Dual Band Wireless Access Point System Requirements Before installing the WAB102, make sure your system meets these requirements: • A 10/100 Mbps Local Area Network device such as a hub or switch. Note: The WAB102 should be connected to a router, switch or hub installed as shown in the figure below. • The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in this package or one like it. • A 100-240 V, 50-60 HZ AC power source. • A Web browser for configuration such as Microsoft Internet Explorer 5.0 or above, or Netscape Navigator 4.78 or later version. • At least one computer with the TCP/IP protocol installed. • Other 802.11a or 802.11b-compliant devices, such as the NETGEAR WAB501 Dual Band Wireless Adapter. WAB102 Dual Band Wireless Access Point Wireless PC Card in a Notebook Computer Router, Switch, or Hub on an Ethernet LAN Introduction Cable or DSL modem 3