Netgear WG602v3 WG602v3 User Manual - Page 45
Upgrading the Wireless Access Point Software, Station List, Management, Refresh - firmware download
View all Netgear WG602v3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual To view the Station List: 1. From under Management on the main menu of the browser interface, click Station List. The Status List screen will display. Figure 3-2 For each device, the table shows the MAC address and whether the device is allowed to communicate with the wireless access point or not. Note that if the wireless access point is rebooted, the table data is lost until the wireless access point rediscovers the devices. 2. Click Refresh to force the wireless access point to look for associated devices. Note: A wireless network can include multiple wireless access points, all using the same network name (SSID). This will extend the reach of the wireless network and allow users to roam from one access point to another, providing seamless network connectivity. However, only the stations associated with this wireless access point will be included in the Station List. Upgrading the Wireless Access Point Software Upgrade files can be downloaded from the NETGEAR Web site. If the upgrade file is compressed (.ZIP file), you must first extract the image (.TRX) file before uploading it to the wireless access point. The upgrade file can be sent using your browser. You cannot perform the firmware upgrade from a workstation connected to the WG602v3 via a wireless link. The firmware upgrade must be performed by a workstation connected to the WG602v3 through the Ethernet LAN interface. Note: The Web browser used to upload new firmware into the WG602v3 must support HTTP uploads, such as Microsoft Internet Explorer 5.0 or above, or Netscape Navigator 4.78 or above. Management 3-3 v1.0, August 2006