Netgear WGR101 WGR101 Reference Manual - Page 39
Default Factory Settings, How to Set Up and Test Basic Wireless Connectivity, admin, password
UPC - 606449036497
View all Netgear WGR101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Reference Manual for the 54 Mbps Wireless Travel Router WGR101 Default Factory Settings The WGR101 default factory settings are shown below. You can restore these defaults by pressing and holding the Factory Default Restore button on the rear panel for 10 seconds. After you install the WGR101 wireless travel router, use the procedures below to customize any of the settings to better meet your networking needs. FEATURE Wireless Access Point Wireless Access List (MAC Filtering) SSID broadcast SSID 11b/g RF Channel Mode Authentication Type WEP DEFAULT FACTORY SETTINGS Enabled All wireless stations allowed Enabled NETGEAR-TRAVEL 11 g and b Automatic Disabled How to Set Up and Test Basic Wireless Connectivity Note: If you use a wireless computer to configure wireless settings, you will be disconnected when you click Apply. Reconfigure your wireless adapter to match the new settings or access the wireless travel router from a wired computer to make any further changes. Follow the instructions below to set up and test basic wireless connectivity. Once you have established basic wireless connectivity, you can enable security settings appropriate to your needs. 1. Log in to the WGR101 at its default LAN address of http://192.168.0.1 with its default user name of admin and default password of password, or using whatever LAN address and password you have set up. 2. Click Wireless Settings in the main menu of the WGR101. 3. Choose a suitable descriptive name for the wireless network name (SSID). In the SSID box, enter a value of up to 32 alphanumeric characters. The default SSID is NETGEAR-TRAVEL. Wireless Configuration 4-7 February 2005 (202-10034-03)