Nikon 25547 User Manual - Page 106

Troubleshooting, below before consulting your retailer or Nikon representative.

Get Nikon 25547 - Coolpix S6 Digital Camera PDF manuals and user guides
UPC - 018208255474
View all Nikon 25547 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 106 highlights

Display Problem Solution SYSTEM ERROR Error has camera's cuitry. occurred in internal cir- Turn camera off, remove and reinsert batteries, and turn camera on. If error persists, contact retailer or Nikon representative. 14 PRINTER ERROR CHECK PRINTER STATUS Printer error. Check printer. To resume, highlight Resume (if available) and press . - Troubleshooting If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon representative. Refer to the page numbers in the right-most column for more information. Problem Solution Camera turns off without warning • Battery is low. • Camera has turned off automatically to save power. • Battery is cold. 14 14 106 • Camera is off. 14 • Battery is exhausted. 14 • Standby mode: monitor turns on when controls are used. 14 Monitor is blank • Flash lamp blinks red: wait until flash has charged. • USB cable is connected. 20 55, 58 • A/V cable is connected. 54 • Time lapse or interval timer photography in progress: mon- 36, 77 itor turns off automatically between shots No indicators appear in monitor Hide info is selected for Photo info. Select Show info. 86 • Monitor has dimmed to save power: monitor brightens 14 Monitor is hard to when controls are used. read • Adjust monitor brightness. 86 • Monitor is dirty: clean monitor. 92 Technical Notes Electronically Controlled Cameras In extremely rare instances, unusual characters may appear in the monitor and the camera may stop functioning. In most cases, this phenomenon is caused by a strong external static charge. Turn the camera off, remove and replace the batteries, and then turn the camera on again. In the event of continued malfunction, contact your retailer or Nikon representative. Note that disconnecting the power source as described above may result in the loss of any data not recorded to internal memory or the memory card at the time the problem occurred. Data already recorded will not be affected. 96

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
96
Technical Notes
Display
Problem
Solution
SYSTEM ERROR
Error has occurred in
camera’s
internal
cir-
cuitry.
Turn camera off, remove and reinsert
batteries, and turn camera on.
If error
persists, contact retailer or Nikon rep-
resentative.
14
PRINTER ERROR
CHECK PRINTER STATUS
Printer error.
Check printer.
To resume, highlight
Resume
(if available) and press
.
—
Troubleshooting
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon representative.
Refer to the page
numbers in the right-most column for more information.
Problem
Solution
Camera turns off
without warning
• Battery is low.
• Camera has turned off automatically to save power.
• Battery is cold.
14
14
106
Monitor is blank
• Camera is off.
• Battery is exhausted.
• Standby mode: monitor turns on when controls are used.
• Flash lamp blinks red: wait until flash has charged.
• USB cable is connected.
• A/V cable is connected.
• Time lapse or interval timer photography in progress: mon-
itor turns off automatically between shots
14
14
14
20
55, 58
54
36, 77
No indicators appear
in monitor
Hide info
is selected for
Photo info
.
Select
Show info
.
86
Monitor is hard to
read
• Monitor has dimmed to save power: monitor brightens
when controls are used.
• Adjust monitor brightness.
• Monitor is dirty: clean monitor.
14
86
92
In extremely rare instances, unusual characters may appear in the monitor and the cam-
era may stop functioning.
In most cases, this phenomenon is caused by a strong external
static charge.
Turn the camera off, remove and replace the batteries, and then turn the
camera on again.
In the event of continued malfunction, contact your retailer or Nikon
representative.
Note that disconnecting the power source as described above may result
in the loss of any data not recorded to internal memory or the memory card at the time
the problem occurred.
Data already recorded will not be affected.
Electronically Controlled Cameras