Nikon D5300 Reference Manual - Page 126
Check the results., Measuring Preset White Balance, Auto off timers, Preset White Balance
View all Nikon D5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
6 Check the results. If the camera was able to measure a value for white balance, the message shown at right will be displayed and a will flash in the viewfinder for about eight seconds before the camera returns to shooting mode. To return to shooting mode immediately, press the shutter-release button halfway. If lighting is too dark or too bright, the camera may be unable to measure white balance. A message will appear in the information display and a flashing b a will appear in the viewfinder for about eight seconds. Return to Step 5 and measure white balance again. D Measuring Preset White Balance If no operations are performed while the displays are flashing, direct measurement mode will end in the time selected for Custom Setting c2 (Auto off timers; 0 186). The default setting is eight seconds. D Preset White Balance The camera can store only one value for preset white balance at a time; the existing value will be replaced when a new value is measured. Note that exposure is automatically increased by 1 EV when measuring white balance; when shooting in mode M, adjust exposure so that the exposure indicator shows ±0 (0 87). A Other Methods for Measuring Preset White Balance To enter preset measurement mode (see above) after selecting preset white balance in the information display (0 101), press J for a few seconds. If white balance has been assigned to the Fn button (0 193), white balance preset measurement mode can be activated by keeping the Fn button pressed for a few seconds after selecting preset white balance with the Fn button and command dial. A Gray Panels For more precise results, measure white balance using a standard gray panel. 106 P, S, A, and M Modes