NordicTrack Audio Rider R400 Bike English Manual - Page 6

Tighten the Upright Knob 7 into the Frame 1.

Get NordicTrack Audio Rider R400 Bike PDF manuals and user guides View all NordicTrack Audio Rider R400 Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

2. While another person lifts the rear of the Frame (1), 2 attach the Rear Stabilizer (16) to the Frame with four M8 x 50mm Button Screws (52) and four M8 Split Washers (55). 3. Tighten the Upright Knob (7) into the Frame (1). 3 1 16 55 55 52 52 7 1 4. Have another person hold the Upright (2) near the front of the Frame (1). Locate the wire tie (see the inset drawing) in the Upright. Tie the lower end of the wire tie to the Main Wire Harness (43). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Attach the Upright (2) to the Frame (1) with an M10 x 63mm Bolt Set (62). Be careful to avoid pinching the Main Wire Harness (43). 4 Avoid pinching and damaging the wires 2 62 62 1 43 Wire Tie 43 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
6
2.
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with
four M8 x 50mm Button Screws (52) and four M8
Split Washers (55).
52
16
1
4
2
Avoid pinching
and damaging
the wires
1
4.
Have another person hold the Upright (2) near the
front of the Frame (1). Locate the wire tie (see the
inset drawing) in the Upright. Tie the lower end of
the wire tie to the Main Wire Harness (43). Next,
pull the upper end of the wire tie upward out of the
top of the Upright. Then, untie and discard the wire
tie.
Attach the Upright (2) to the Frame (1) with an M10
x 63mm Bolt Set (62).
Be careful to avoid pinch-
ing the Main Wire Harness (43).
2
52
55
55
62
62
43
43
3
7
1
3.
Tighten the Upright Knob (7) into the Frame (1).
Wire Tie