NordicTrack Audio Rider R400 Bike English Manual - Page 7

5. The Console (4) requires four "D" batteries (not included); alkaline batteries are recommended. IMPORTANT: If the exercise cycle has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Remove the battery covers from the back of the Console. Next, insert four batteries into the battery compartments; make sure that the batteries are oriented as shown by the diagrams inside the battery compartments. Then, reattach the battery covers. Note: The Console (4) can be operated with an optional power supply instead of batteries. To purchase a power supply, call the toll-free telephone number on the front cover of this manual. Plug one end of the power supply into the jack at the front of the exercise cycle. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 6. Attach the Handlebar (39) to the Upright (2) with four M6 x 30mm Button Screws (37). 5 Batteries 4 6 2 Battery Covers Batteries 37 7. While another person holds the Console (4) near the Handlebar (39), connect the wire harness on the Console to the Main Wire Harness (43). Next, connect the pulse wire on the Console to the Pulse Wire (51) in the Handlebar (39). Note: The remaining wire on the Console is used during the manufacturing process; disregard this wire. Insert the excess wiring downward into the Upright (2). Attach the Console (4) to the Handlebar (39) and the Upright with four M4 x 16mm Round Head Screws (80). Be careful to avoid pinching the Wires (43, 51). 7 80 80 2 37 39 Wire Harness 43 4 51 Pulse 39 Wire Avoid pinching the Wires (43, 51) during this step 7