NordicTrack Cx 925 Elliptical English Manual - Page 7
How To Use The Elliptical Exerciser
View all NordicTrack Cx 925 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR If you have purchased the optional chest pulse sensor (see page 18), follow the steps below to install the receiver included with the optional chest pulse sensor. 1. Look under the Console (17) and locate the access cover. Remove the access cover. 17 2. Hold the receiver in the position shown, with the small cylinder oriented as shown. Using the two screws included with the chest pulse sensor, attach the receiver to the two plastic posts (not shown) inside the access opening in the back of the Console (17). 3. Connect the wire on the receiver to the indicated wire on the Console (17). Make sure that the connectors on the wires snap together. Discard the other wires included with the chest pulse sensor. 4. Reattach the access cover to the Console (17). Cylinder Receiver Access Cover Screws HOW TO USE THE ELLIPTICAL EXERCISER EXERCISING ON THE ELLIPTICAL EXERCISER To mount the elliptical exerciser, hold the handgrip pulse sensor and step onto the pedal that is in the lowest position. Next, step onto the other pedal. Push the pedals until they begin to move with a continuous motion. To dismount the elliptical exerciser, wait until the pedals come to a complete stop. The elliptical exerciser does not have a free wheel; the pedals will continue to move until the flywheel stops. When the pedals are stationary, step off the highest pedal first. Then, step off the lowest pedal. Handgrip Pulse Sensor Pedals 7