NordicTrack E 9.2 Elliptical Uk Manual - Page 28

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If lines appear in the console display, see step 4 on page 27 and adjust the contrast level of the display. If the handgrip heart rate monitor does not function properly, see step 5 on page 21. If the console does not display your heart rate when you use the chest heart rate monitor, see TROUBLESHOOTING on page 15. HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the left pedal, the top shield cover, the rear shield cover, and the left shield. First, unplug the power adapter. Then, see step 15 on page 13 and remove the left pedal. Next, see step 16 on page 14 and remove the rear shield cover. Then, see step 5 on page 8 and release the top shield cover from the left shield. Slide the top shield cover upward. Remove the M4 x 16mm Screws (92) from the Left Shield (44) and then gently move the Left Shield outward over the Left Pedal Arm (14). 14 92 92 44 92 92 Next, loosen the Pivot Screw (88). Then, tighten the Drive Belt Adjustment Screw (72) until the Drive Belt (46) is tight. 46 88 72 When the Drive Belt (46) is tight, tighten the Pivot Screw (88). Then, reattach the left shield, the rear shield cover, the top shield cover, and the left pedal. Plug in the power adapter. 28