NordicTrack Elite 7.4 Bike English Manual - Page 29

HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power adapter (not shown). Next, use an adjustable wrench to turn the Left Pedal (22) clockwise 22 and remove it. Using a standard screwdriver, gently release the tabs on the left Shield Disc (52). Rotate the Shield Disc and remove it. Then, gently remove the Left Front Shield (13). Next, loosen the M6 x 20mm Hex Screw (84). Tighten the M10 x 50mm Hex Screw (83) until the Drive Belt (47) is tight. When the Drive Belt is tight, tighten the M6 x 20mm Hex Screw. 47 84 See EXPLODED DRAWING A on page 34. Using a standard screwdriver, gently release the tabs on the Front Shield (58) and the Top Shield (44) and remove them. Next, locate the Left and Right Front Shields (13, 14). Remove all the Screws (77, 85) from the Left and Right Front Shields; make sure to note the location of each size of Screw. 83 When the drive belt is correctly adjusted, reattach the left and right shields, the top shield, the front shield, the left pedal disc, and the left pedal. Then, plug in the power adapter. 29