NordicTrack Ellipse 910 Elliptical English Manual - Page 11
Maintenance, Trouble, Shooting
View all NordicTrack Ellipse 910 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
MAINTENANCE AND TROUBLE-SHOOTING Inspect and tighten all parts of the elliptical crosstrainer every three months or as needed. Replace any worn parts immediately. The elliptical crosstrainer can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console does not function properly, the batteries should be replaced. For battery replacement instructions, refer to assembly step 8 on page 8. Note: It is not necessary to remove the console to replace the batteries. The batteries can be replaced thought the access hole underneath the console. If the console does not function properly after new batteries are installed, make sure that the magnet clip is in the proper position. The magnet clip should be seated in the hole in the right handlebar. Hole Battery Clip LUBRICATING THE ELLIPTICAL CROSSTRAINER If the axles of the elliptical crosstrainer squeak as you exercise, apply a drop of household oil to each axle. Do not use spray lubricants. Never remove the side shields. Lubricate ADJUSTING THE LOCKNUTS ON THE PEDAL ARMS AND HANDLEBAR POSTS If the elliptical crosstrainer does not move smoothly as you exercise, the nylon locknuts on the pedal arms and the handlebar posts can be adjusted. First, remove the three indicated nut caps from each side of Locknuts O ca 'Nut Caps Nut Cap the elliptical crosstrainer. Next, loosen the indicated Innknnts nn each side of the elliptinel crosstrainer about 1/4 turn. Exercise for a moment to see if the elliptical crosstrainer moves smoothly. If necessary, loosen the locknuts another 1/4 turn. Repeat this process until the elliptical crosstrainer moves smoothly. When the locknuts are properly adjusted, reattach the cap nuts.