NordicTrack Ellipse 910 Elliptical English Manual - Page 5

ASSEMBLY Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires only the included tool. As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. O M5 Split Washer (74)-4 Pedal Washer (72)-4 Star Washer (75)-7 M10 Split Washer (78)-2 Console Screw (19)-5 co M6 Nylon Locknut (68)-8 M10 Nylon Locknut (34)-8 Nut Cap (33)-8 M10 Flat Washer (36)-6 L) Upright Screw (76)-7 Handlebar Bolt (73)-4 Pedal Bolt (69)-4 Stabilizer Bolt (32)-2 Pivot Shaft (37)-4 1. Hold the Front Stabilizer (30) against the curved bracket on the Frame (1). Make sure that the Front Stabilizer is turned so the foam pads are facing the curved 30 bracket. Attach the Front Stabilizer with the two 32 Stabilizer Bolts (32), two M10 Split Washers (78), and two M10 Nylon Locknuts (34). Press a plastic Nut Cap (33) onto each Nylon Locknut. a- 34 7 33 34