NordicTrack Gxr4.1 Bike Uk Manual - Page 8

5. Make sure that the Wire Harness (89) and the Frame Pulse Wire (91) are in the location shown. Using a small plastic bag to keep your fingers clean, apply a coat of the included grease to an M6 x 70mm Bolt Set (67). Tip: Avoid pinching the wires. Attach the Handlebar (6) to the Upright (4) with the M6 x 70mm Bolt Set (67) and two M8 x 20mm Washers (70). Then, attach an M6 x 60mm Bolt Set (68) through the bracket on the Handlebar (6). Make sure that the Bolt Set is inside the bracket. 5 67 70 68 Avoid pinching the wires 6 68 Bracket 70 Grease 67 91 89 4 6. Insert the Wire Harness (89) and the Frame Pulse Wire (91) upward through the indicated 6 hole in the Handlebar (6). 6 91 89 7. While another person holds the Console (7) near the Handlebar (6), insert the long receiver wire (A) through the Handlebar (6) as shown. Then, connect the other wires on the Console to the Wire Harness (89) and to the Frame Pulse Wire (91). Tip: Avoid pinching the wires. Attach the Console (7) to the Handlebar (6) with four M4 x 16mm Screws (98). 7 7 6 A 98 91 98 89 Avoid pinching 4 the wires 8