NordicTrack Professional Series 4000 Treadmill English Manual - Page 25

HOW TO OPERATE THE PERSONAL TELEVISION IMPORTANT: Before operating the television, you must connect an antenna, a 75 ohm CATV cable, or a VCR to the 75 ohm antenna terminal on the treadmill. See page 9 for instructions. Follow the steps below to operate the television. 1 Insert the key into the console. See GETTING STARTED on page 13. 2 Select the desired channel. Press the CHANNEL + and - buttons to select a channel. The number of the selected channel will appear in the main display. 3 Adjust the volume. Press the VOLUME + and - buttons to select the desired volume. The selected volume setting will appear in the main display. 5 Press the RESET button and enable or disable the TV. If the words TV POWER ON appear in the main display when the RESET button is pressed, the television will turn on each time the key is inserted. To prevent the TV from being used, press the + or - button above the ENTER AGE/WT button so the words TV POWER OFF appear in the main display. If you have enabled the TV, go to step 6. If you have disabled the TV, go to step 9. 6 Press the RESET button again and select a cable connection or an antenna connection. If you are using a cable connection, press the + or - button above the ENTER AGE/WT button until the words TV MODE CABLE appear in the main display. If you are using an antenna connection, press the + or - button until the words TV MODE ANTENNA appear. 7 Press the RESET button again and program TV channels. Note: To listen to television programs using headphones (not included), plug the headphones into the indicated jack on the left side of the console. Jack When the RESET button is pressed, the words CHANNEL SCAN will appear in the main display. The console has the capability to find and store in memory all of the valid TV channels in your area. Press the + or - button above the ENTER AGE/WT button to start the channel scanning process. 4 Change television settings if desired. To change television settings, hold down the CHANNEL + and - buttons for a few seconds until the words TV SETUP appear in the main display, The console will begin scanning all TV channels. If no broadcast signal is detected on a channel, the channel will be skipped; if a signal is detected, a tone will sound and the channel will be stored in memory. This process will continue until the highest channel is reached. The lowest channel stored in memory will then appear in the main display. 25