NordicTrack Professional Series 4000 Treadmill English Manual - Page 8

4. Be careful to avoid pinching your hands, the Wire Harnesses (not shown), or the TV Cable (not shown) during this step. While a second person holds the Uprights (95, 97), remove the two Upright Bolts (96) used in step 1. Next, slide the Uprights fully onto the brackets on the Frame (not shown). Attach each Upright with four Upright Bolts (96) as shown. Firmly tighten all eight Upright Bolts. Firmly tighten the eight Handrail Bolts (99). 4 99 99 97 96 5. Plug the indicated end of the Power Cord (48) fully into the treadmill as shown. 5 99 95 96 48 6. After the treadmill is moved to the location where it will 6 be used (see HOW TO MOVE THE TREADMILL on page 30), make sure that both Rear Feet (5) and both Wheels (not shown) rest firmly on your floor. If the treadmill rocks slightly on your floor, loosen the Rear Foot Locknut (113) above the right Rear Foot. Turn the right Rear Foot clockwise or counterclockwise until the rocking motion is eliminated. Then, retighten the Rear Foot Locknut. 113 5 7. Note the location of the 75 ohm antenna terminal on 7 the treadmill. For the television to operate properly, an antenna, a 75 ohm CATV cable, or a VCR must be connected to the 75 ohm antenna terminal (see page 9). 113 5 75 Ohm Antenna Terminal 8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill. 8