Oki B6300 B6200/6300 Technical Reference/User's Guide - Page 104
Message, Condition/Reason/Action - fuser reset
View all Oki B6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Message Ejecting... xxxx Tray * Empty Center Output Tray Ended with Error xxx-xxx Incorrect paper type Reselect SEL to print CANCEL to cancel Initializing PostScript... Load Tray * xxxx XXXX Lower Rear OutputTray lever Off-line Off-line Data in memory Open Cover A or B Clear jam Open Cover C and remove paper Open Cover D and remove paper Open Cover A, C then B Clear jam Condition/Reason/Action The printer is outputting print data. The printer can receive print data from a computer during processing. The center output tray is full. Remove paper from the center output tray. An error has occurred and printing does not finish successfully. Check the error code "xxx-xxx" displayed in the screen and perform the appropriate procedures. Refer to • "List of Error Codes" (P. 102) Paper of the type specified under [Paper Type] in the printer driver is not loaded in the trays. Press the button on the control panel to print on paper of another type or press the button to cancel the job. This indicates that the printer system is being initialized. This is displayed when the power is switched on or the system is reset. There is no paper whose size and orientation is "xxxx" and whose paper type is "XXXX" left in the tray. Load paper whose size and orientation is "xxxx" and whose paper type is "XXXX" into the tray * . Refer to • "Loading Paper in a Paper Tray" (P. 47) Since the rear tray is set as the output destination, the printer cannot output to the center output tray. Push down the rear output tray lever and change the output destination to the center output tray. The printer is offline as the button has been pressed. To cancel the offline status, press the button again. Note • The printer cannot receive any print data from the computer while it is offline. Paper jam has occurred around the printer fuser unit. Open cover A or B of the printer to remove the jammed paper. Refer to • "5.1 When Paper Jams" (P. 89) Paper jam has occurred around the printer duplex unit. Open cover C of the printer to remove the jammed paper. Refer to • "5.1 When Paper Jams" (P. 89) Paper jam has occurred in the offset catch tray of the printer. Open cover D of the printer to remove the jammed paper. Refer to • "5.1 When Paper Jams" (P. 89) Paper jam has occurred around the printer fuser unit. Open covers A, C, and B in sequence to remove the jammed paper. Refer to • "5.1 When Paper Jams" (P. 89) 100 5 Troubleshooting