Oki B6300 B6200/6300 Technical Reference/User's Guide - Page 74
Port9100
View all Oki B6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Port9100 Select this to use Port9100. n Port Status Specifies whether to enable or disable the Port9100 port when the printer turns on. The default is [Enable], which means the Port9100 port is available. Note • To enable the Port9100 port, the IP address must be set. Important • If the memory is running out when the port is enabled, the port may be disabled automatically. In this case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate Memory]. n Print Mode*1 (refer to P. 83) Sets the print data process method (printer language to be used). [Auto] (default) Select this to make the printer automatically detect the printer language being used in the data received from a computer and perform printing based on the detected data. [PCL] [PS] [ESC/P] [HP-GL/2] [TIFF] Select this to process the data received from a computer as the specified data type. n PJL *2 (refer to P. 83) This printer supports PJL commands that are independent from any printer languages. The PJL commands are used to control print jobs and are required for printing using a printer driver. In this menu, specify whether to enable or disable the PJL commands sent from a computer. PJL commands allow you to specify the printer language to be used for the next data even while the printer is using a different printer language at the time. Normally, it should be set to [Enable]. The default is [Enable]. n Connect Time-Out *3 (refer to P. 83) Specifies the time interval for disconnection when no further data is received. You can specify a value between 2 and 65535 seconds in increments of 1 second. The default is [60 Secs]. n Port No. Set the port number to 9100 or a value between 8000 and 9999. The default is [9100]. n TBCP Filter Specifies whether to enable or disable the TBCP filter when processing PostScript data. The default is [Disable]. 70 4 Settings on the Control Panel