Olympus 300 Digital Stylus 300 Digital Reference Manual (English) - Page 121
The flash does not fire., The monitor is hard to see.
UPC - 050332140202
View all Olympus 300 Digital manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Troubleshooting The subject is not displayed on the monitor. Possible cause Corrective action The monitor was turned off before closing the lens barrier. If All Reset in the SETUP tab of the mode menu is set to "OFF," the camera settings before the lens barrier was closed remain unchanged. Turn on the monitor, and close the lens barrier. You are taking sequential No image appears on the monitor during shots. sequential shooting. Ref. Page P.101 P.70 The colors of the image in the monitor are blurred when the camera is focusing. Possible cause Corrective action Ref. Page The colors of the image in This is not a malfunction. The image will be - the monitor may be displayed clearly when focusing is complete. blurred when the shutter button is pressed halfway. The flash does not fire. Possible cause The flash is set to the flash off mode. The subject is illuminated. The camera is in movie mode. Panorama mode is set. Corrective action Select a flash mode other than flash off. Ref. Page P.62 If you want the flash to fire on a brightly illuminated subject, set the flash to fill-in mode. The flash is disabled in the movie mode. P.62 P.57 The flash does not fire in the panorama mode. Cancel the panorama mode. P.71 9 The monitor is hard to see. Possible cause Corrective action Ref. Page Miscellaneous Vertical lines appear on the monitor. This sometimes occurs when the camera is aimed at a bright subject in sunlight. It is not a malfunction. P.51 The brightness is not adjusted properly. Select in the mode menu and then adjust the brightness. P.106 The monitor is exposed to Block the sunlight with your hand. - direct sunlight. 120