Onkyo CP-1050 User Manual English - Page 10
Connections
View all Onkyo CP-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Connections Amplifier to an AC outlet 1. Connection with the amplifier Connect the supplied pin cables with attached grounding to the PHONO OUTPUT terminals on the rear panel of the unit and the PHONO input terminals of the amplifier. Connect the red plug to the R terminal and the white plug to the L terminal respectively. In addition, connect the grounding line of the pin cables with attached grounding to the GND terminal (ground terminal) of the rear panel of the unit and the amplifier. About the amplifier If there is no PHONO input terminal on the amplifier used, connect a commercial phono-equalizer between the unit and the amplifier. See the instruction manual of the phono-equalizer for the connection method. 3. Mounting the dust cover 1. Insert the two supplied dust cover hinges fully into the holder on the rear panel of the unit. 2. Adjust the square holes of the dust cover to the hinges and insert them fully into the hinges. Hinge 2. Connecting the power cord Do not use a power cord other than the one supplied with this unit. Before connecting the power cord, connect all of your components. Always connect the power cord to an AC outlet only after connecting it to the AC INLET terminal of the unit. Disconnect the power cord only after turning the unit off. To avoid electrical shock, always disconnect the power cord from the AC outlet before disconnecting the other end. Holder Opening and closing the dust cover Open and close the dust cover slowly. The stylus may jump if the player is subjected to shock during a musical performance. Removing the dust cover After opening the dust cover fully, hold the dust cover at the back on both sides and pull it out from the top. 10