Onkyo HT-RC360 Owner Manual - Page 12

Connections Connecting the AV Receiver Connecting Your Speakers Connecting the Speaker Cables The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals. Surround right Surround left Surround back/ Front high right Surround back/ Front high left Front right Front left Center Tip • You can specify whether surround back or front high speakers are connected in the "Speaker Configuration" menu (➔ page 43) or during Audyssey 2EQ® Room Correction and Speaker Setup (➔ page 29). ■ Screw-type speaker terminals Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 1/2" to 5/8" (12 to 15 mm) ■ Banana Plugs (North American models) • If you are using banana plugs, tighten the speaker terminal before inserting the banana plug. • Do not insert the speaker code directly into the center hole of the speaker terminal. ■ Push-type speaker terminals Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 3/8" to 1/2"(10 to 12 mm) En 12