Onkyo HT-S5300 Owner Manual - Page 43
Digital Input Signal Formats, Adjusting the Bass & Treble, A/V Sync - reset
View all Onkyo HT-S5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
A/V Sync When using progressive scanning on your Blu-ray Disc/ DVD player, you may find that the picture and sound are out of sync. With this setting, you can correct this by delaying the audio signals. ■ A/V Sync `0 ms to 100 ms in 10 ms steps Note • A/V Sync is disabled when the Direct listening mode is used with an analog input source. • The setting is stored individually for each input selector. Digital Input Signal Formats The digital input signal formats are available only for the input sources that you have assigned a digital input jack (➔ 34). Normally, the AV receiver detects the signal format automatically. However, if you experience either of the following issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS. Note • If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM. • If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS. • The setting is stored individually for each input selector. • The setting will be reset to "Auto" when you change the setting in the "Audio Selector" (➔ 42). 1 Press RECEIVER, and then press and hold AUDIO for about 8 seconds. 2 While "Auto" lights (about 3 seconds), press F/S to select: ` Auto: The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead. ` PCM: Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indicator will flash and noise may also be produced. ` DTS: Only DTS (but not DTS-HD) format input signals will be heard. If the input signal is not DTS, the DTS indicator will flash and there will be no sound. Adjusting the Bass & Treble You can adjust the bass and treble for the front speakers, except when the Direct listening mode is selected. 1 Press TONE on the AV receiver repeatedly to select either "Bass" or "Treble". 2 Use TONE -/+ on the AV receiver to adjust. ■ Bass ■ Treble See "Bass" and "Treble" of "Tone Control Settings" (➔ 41). Note • To bypass the bass and treble tone circuits, select the Direct lis- tening mode. • This procedure can also be performed on the remote controller by using AUDIO (➔ 41). En 43