Onkyo HT-S5300 Owner Manual - Page 45

Setting the Powered Zone 2 If you've connected your Zone 2 speakers to the AV receiver, as explained in "Connecting Your Zone 2 Speakers Directly to the AV receiver" (➔ 44), you must set the "Front High/Zone2" setting to "Zone2". Menu Hardware 1 Press RECEIVER followed by SETUP. The setup menu appears. 2 Use R/X to select "Hardware", and then press ENTER. 3 Use R/X to select "Front High/Zone2", and F/S to select "Zone2". ` Zone2: FRONT HIGH OR ZONE2 L/R speaker terminals activated (Powered Zone 2 enabled). Using Zone 2 This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2. Controlling Zone 2 from the AV receiver ZONE2 OFF -/+ Note • When "Zone2" is selected and Zone 2 turned on, the Zone 2 speakers connected to the FRONT HIGH OR ZONE2 L/R speaker terminals output sound, but the surround back or front high speakers connected to the SURR BACK OR FRONT HIGH L/R speaker terminals do not. When "Zone2" is selected and Zone 2 turned off, the surround back or front high speakers output sound as normal. • When the "Front High/Zone2" setting is set to "Zone2" and the input selector of Zone 2 is selected, power consumption on standby mode slightly increases. ZONE 2 indicator Input selector buttons 1 To turn on Zone 2 and select an input source, press ZONE 2 on the AV receiver followed by an input selector button within 8 seconds. Zone 2 turns on, the ZONE 2 indicator lights. To select AM or FM press the TUNER input selector button repeatedly. To select the same source as that of the main room, press ZONE 2 repeatedly until "Z2 Selector: Source" appears on the display. Note • You cannot select different AM or FM radio stations for your main room and Zone 2. The same FM/AM radio station will be heard in each room. 2 To turn off Zone 2, press OFF on the AV receiver. Note • While Powered Zone 2 is being used, listening modes that require surround back and front high speakers (6.1/7.1), such as Dolby Pro Logic IIz Height, Dolby Digital EX, and DTS-ES are unavailable. • When the "Front High/Zone2" setting is set to "Zone2" and the input selector of Zone 2 is selected, power consumption on standby mode slightly increases. En 45