Onkyo HT-SP904 Owner Manual - Page 17

Speakers Subwoofer (SKW-750) For detailed information, see the pages in parentheses. ■ Front 1 ■ Rear A STANDBY/ON indicator Red: Subwoofer in standby mode Green: Subwoofer on With the Auto Standby function, the SKW-750 automatically turns on when an input signal is detected in Standby mode. When there's no input signal for a while, the SKW-750 automatically enters Standby mode. B OUTPUT LEVEL control (42) This control is used to adjust the volume of the subwoofer. C LINE INPUT (19) This RCA input should be connected to the subwoofer pre out on the AV receiver with supplied RCA cable. Note: The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on the AV receiver (page 60). To AC outlet 23 Front, Center & Surround speakers (SKF-750F, SKC-750C, SKM-750S) ■ Rear 3 1 Keyhole slots These keyhole slots can be used to wall-mount the speaker. 2 Speaker terminals These push terminals are for connecting the speaker to your AV Receiver, amp, or other receiver with the supplied speaker cables. The supplied speaker cables are color-coded for easy identification. Sim- 1 ply connect each cable to the same-colored positive 2 speaker terminal. 3 Speaker mount/bracket inserts These threaded inserts can be used to attach the speaker either horizontally or vertically to a speaker mount or bracket. Note: Use commercially available 1/4" screws to attach the speaker to a speaker mount or bracket. 17