Onkyo TX-DS898 Owner Manual - Page 13

Rear panel facilities PRE OUT These jacks are for connecting auxiliary power amplifier. Using auxiliary power amplifiers allows you to listen at louder volumes than with the TX-DS898 alone. If power amplifiers are used, connect each speaker to the corresponding power amplifier. Front input L (white) R (red) Subwoofer Surround back L (white) DIGITAL OUTPUT OPT 1 PRE OUT R L FRONT SUB CENTER 2 COAX 1 2 SURR SURR BACK / ZONE 2 R (red) 3 Surround input FRONT L (white) MULTI C INPUT R (red) Center ZONE 2 AUDIO/VIDEO OUT Connect the device that will be used in the remote zone (Zone 2). For more information regarding how to make the connections, refer to "Connecting the remote zone (Zone 2) speakers" on page 21. COMPONENT VIDEO INPUT/OUTPUT If your DVD player or other device has component video connectors, be sure to connect them to these component video connectors on the TX-DS898. The TX-DS898 has two component video input connectors to obtain the color information (Y, PB, PR) directly from the recorded DVD signal or other video component and one component video output connector to output it directly into the matrix decoder of the display device. By sending the pure DVD component video signal directly, the DVD signal forgoes the extra processing that normally would degrade the image. The result is vastly increased image quality, with incredibly lifelike colors and crisp detail. Y PB PR RCA type Power amplifier 1 2 3 4 5 67 8 1. Front left speaker 2. Front right speaker 3. Subwoofer 4. Surround back left speaker 5. Surround back right speaker 6. Surround left speaker 7. Surround right speaker 8. Center speaker ANTENNA These jacks are for connecting the FM indoor antenna and AM loop antenna that are supplied with the TX-DS898. AUDIO IN/OUT These are the analog audio inputs and outputs. There are eight audio inputs and 3 audio outputs. The audio inputs and outputs require RCA-type connectors. • When connecting a VCR or other video component, make sure you connect the audio and video leads together (i.e., both to VIDEO 3). • The PHONO (PH) input jacks on the TX-DS898 is designed for use with turntables that use moving magnet cartridges. RCA type SPEAKERS Seven terminals are provided for the front left, front right, front center, surround left, surround right, surround back left, and surround back right speakers. Speaker outputs are compatible with banana plug connectors. AC OUTLETS The TX-DS898 is supplied with AC mains outlets for connecting the power cords from other devices so that their power is supplied through the TX-DS898. By doing this, you can use the STANDBY/ ON button on the TX-DS898 to turn on and off the connected devices as well. Caution: Make sure that the total capacity of the other components connected to this unit does not exceed the capacity that is printed on the rear panel (e.g., 120 watts). AC OUTLETS AC 120V 60 Hz SWITCHED TOTAL 120W 1A MAX. MONITOR OUT The monitor output includes both composite video and S video configurations. This output is for connecting television monitors or projectors. 12V TRIGGER/ZONE 2 terminal When the TX-DS898 is in the ZONE 2 mode, this terminal outputs at 12 V/100 mA. 13