Onkyo TX-DS898 Owner Manual - Page 25
Connecting the power
View all Onkyo TX-DS898 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connecting the power STANDBY/ON STANDBY indicator STANDBY/ON STANDBY POWER ON OFF ZONE 2 (GRN ) AUDIO REC ( RED) DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 TAPE FM PURE AUDIO UPSAMPLING SELECTOR AM PHONO C D DISPL AY MASTER VOLUME PUSH TO OPEN POWER TX-DS898 TAPE To wall outlet ON RCVR STDBY • The TX-DS898 is shipped with the main power (POWER) switch in the on position ( ON ). When the power cord is plugged in for the first time, the TX-DS898 will automatically enter the standby state and the STANDBY indicator will light (same condition after step 2 below). • Before you plug in the TX-DS898, confirm that all connections have been made properly. • Turning on the power may cause a momentary power surge, which might interfere with other electrical equipment on the same circuit, such as computers. If this happens, use a wall outlet on a different circuit. 1. Plug the power cord into an AC wall outlet. STAND 2. Press the POWER switch to set the TX-DS898 to standby state. POWER The STANDBY indicator will light up. ON OFF 3. Press the STANDBY/ON button to turn on the TX-DS898. The display and four jog dial indicators will light up and the STANDBY indicator will turn off. If you press the STANDBY/ON button again, the receiver returns to Standby mode. STANDBY/ON STANDBY Turn off Turning the power on from the remote controller: Before you can use the remote controller, you must perform steps 1 and 2 above and place the TX-DS898 in the standby state. 1. Press the RCVR MODE button. The RCVR MODE button lights green. To change the display of the input source from TAPE to MD: If you connected an MD recorder to the TAPE jack on the TXDS898, you can have "MD" appear when the TAPE source button is pressed. By changing the display, if an Onkyo MD recorder zconnected, the z system functions will become enabled. Changing the display: Press and hold down the TAPE source button until the display changes from TAPE to MD (approx. 3 seconds). TAPE To return the display to its original setting, perform the same procedure. This setting is necessary to allow z system functions for the connected cassette tape or MD recorder. Memory preservation This unit does not require memory preservation batteries. A builtin memory power backup system preserves the contents of the memory during power failures and even when the POWER switch is set to off. The POWER switch must be set to on in order to charge the backup system. The memory preservation period after the unit has been turned off varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been turned off. This period is shorter when the unit is exposed to a highly humid climate. 2. Press the ON button to turn on the TX-DS898 (take it out of the standby state). To return the TX-DS898 to the standby state, press the STDBY button. 25