Onkyo TX-NR515 Owner Manual - Page 82
En-82, Update Procedure, Troubleshooting - firmware update
View all Onkyo TX-NR515 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Update Procedure 1 Press RECEIVER followed by HOME on the remote controller. The Home menu appears on the TV screen. 2 Select "Firmware Update" and press ENTER. Note that the "Firmware Update" option will be grayed out for a short while after the AV receiver is turned on. Please wait until it becomes operable. 3 Select "Update via NET" and press ENTER. 4 Select "Update" and press ENTER. The update process will begin. During the update process, the on-screen display may disappear depending on the updated program. When this occurs, you can still view the update progress on the AV receiver's display. The on-screen display will reappear after the update is complete, and upon turning the AV receiver off and on again. 5 The message "Completed!" appears on the AV receiver's display, indicating that the update has been completed. 6 Turn off the AV receiver using ON/STANDBY on the front panel. Do not use RECEIVER on the remote controller. Once turned off, the AV receiver will automatically turn on again. Congratulations! You now have the latest firmware installed on your Onkyo AV receiver. Troubleshooting Case 1: If "No Update" is displayed on the AV receiver's display, it means that the firmware has already been updated. You do not need to do anything further. Case 2: If an error occurs, "Error!! *-**" is displayed on the AV receiver's display. (Alpha-numeric characters on the front display are denoted by asterisks.) Refer to the following table and take appropriate action. ■ Errors during an update via network Error Code Description *-10, *-20 The Ethernet cable was not detected. Reconnect the cable properly. *-11, *-13, *-21, Internet connection error. *-28 Check the following items: • Make sure the IP address, subnet mask, gateway address, and DNS server are configured properly. • Make sure the router is turned on. • Make sure the AV receiver and the router are connected with an Ethernet cable. • Make sure your router is configured properly. See the instruction manual of the router. • If your network allows only one client connection and there is any other device already connected, the AV receiver will not be able to access the network. Consult your Internet Service Provider (ISP). • If your modem does not function as a router, you will need a router. Depending on your network, you may need to configure the proxy server if necessary. See the document provided by your ISP. If you are still unable to access the Internet, the DNS or proxy server may be temporarily down. Contact your ISP. Others Retry the update procedure from the beginning. If the error persists, please contact Onkyo Support (➔ page 84) and provide the error code. Appendix Case 3: If an error occurs during the update process, disconnect then reconnect the AC power cord and try again. Case 4: If an error occurs due to a wrong selection of input sources, turn off and on the AV receiver. Then retry the update. Case 5: If you do not have an Internet connection to the network, please contact Onkyo Support (➔ page 84). En-82