Onkyo TX-NR545 Basics Guide - Page 64
En-32
View all Onkyo TX-NR545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Setting Item Height Surround Back LPF of LFE En-32 Default Value 100 Hz 100 Hz 100 Hz 120Hz Setting Details Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. ●● "Full Band" can be selected only when "Front" is set to "Full Band". ●● If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. ●● Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. ●● "Full Band" can be selected only when "Front" is set to "Full Band". ●● If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. "Full Band": Full band will be output. ●● This cannot be selected in the following conditions. - The setting for "Configuration" - "Bi-Amp" is "Yes" - "Configuration" - "Powered Zone 2" is set to "Yes" and ZONE 2 is on ●● "Full Band" can be selected only when "Surround" is set to "Full Band". ●● If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Set the low-pass filter for LFE (low-frequency effect) signals in order to pass lower frequency signals than the set value and thus cancel unwanted noises. The low-pass filter will be effective only on sources with LFE channel. The value from "80Hz" to "120Hz" can be set. "Off": Do not use this function Setting Item Double Bass Advanced Settings (Setup Menu) Default Value On Setting Details This can only be selected when "Configuration" "Subwoofer" is set to "Yes" and "Front" is set to "Full Band". Boost bass output by feeding bass sounds from the front left and right, and center speakers to the subwoofer. "On": Bass output will be boosted. "Off": Bass output will not be boosted. ●● The setting will not automatically be configured even if you performed the automatic speaker setup. Distance Set the distance from each speaker to the listening position. Settings are automatically configured if you use the automatic speaker setup. Setting Item Unit Front Left Center Front Right Height Left Height Right Surround Right Default Value feet/meters 12.0ft/3.60m 12.0ft/3.60m 12.0ft/3.60m 9.0ft/2.70m 9.0ft/2.70m 7.0ft/2.10m Setting Details Specify the unit of distance for configuring settings. "feet": When setting in feet (0.1 ft to 30.0 ft, in increments of 0.1 ft) "meters": When setting in meters (0.03 m to 9.00 m, in increments of 0.03 m) Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. Specify the distance between each speaker and the listening position. ●● This setting cannot be changed if "Configuration" - "Powered Zone 2" is set to "Yes" and Zone2 is set to on. Specify the distance between each speaker and the listening position. ●● This setting cannot be changed if "Configuration" - "Powered Zone 2" is set to "Yes" and Zone2 is set to on. Specify the distance between each speaker and the listening position.