Onkyo TX-NR545 User Manual - Page 18
Step 3
View all Onkyo TX-NR545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
6 Multi-zone You can listen to audio in a room (called Zone 2) other than the one where this unit is located (called the main room). Sources you can playback ●● External players ●● NET ●● Bluetooth ●● AM/FM Radio Important: Connection with external players To listen to a player in Zone 2, you must connect using an RCA cable. Some players may require analog audio output setting. Making Multi-zone Connection There are the following two methods of connection: a. C onnecting with a pre-main amplifier in a separate room b. C onnecting with speakers in a separate room a. Connecting with a pre-main amplifier in a separate room It is possible to play 2 ch source in a separate room while 7.1 ch source is being played in the main room. Connect the LINE OUT ZONE2 jacks of the unit and the line-in jacks of the pre-main amplifier in a separate room with an RCA cable. Step 3: Playing Back b. Connecting with speakers in a separate room Connect the speakers in another room to the SPEAKERS ZONE2 jacks of the unit using speaker cables. Note that 5.1 ch will be the maximum () in the main room during Zone 2 playback. No sound will be output from the back speakers and height speakers. ¼¼In this case, the Dolby Atmos listening mode cannot be selected. AUDIO OUT Main room Main room Zone 2 ●● The volume should be adjusted with the pre-main amplifier used in the separate room. Zone 2 These settings are required: After connecting the speakers, press RECEIVER and then SETUP on the remote controller, select "2. Speaker" "Configuration" and set "Powered Zone2" to "Yes". ●● Adjust the volume on this unit. To adjust the volume, press ZONE2 on the remote controller and then adjust with VOLj/l. To control on the main unit, press ZONE 2 and within 8 seconds, adjust with the MASTER VOLUME control. You can mute the sound by pressing MUTING on the remote controller. En-18