Onkyo TX-NR801 Owner Manual - Page 82

Operating Other Manufacturers' Devices Using the Remote Controller The remote controller has three learning functions. One is entering the pre-programmed code for a remote controller of another manufacturer. Another is the normal learning function that enables the remote controller to learn the codes directly from other remote controllers (See page 86). And the last is a macro learning function that enables you to program a series of operations into the remote controller so that the operations can all be performed at once by pressing one button (See page 88). Learning a Pre-programming Code By entering a pre-programming code, you can have the RC-511M remote controller operate a component made by another manufacturer. The buttons that are used for operation are given on pages 84-85. SEND/LEARN indicator Buttons that can be pre-programmed VOL DISPLAY Numeric keys Caution With some brand's components, some buttons may not work correctly. In this case, program the command directly from the other remote controller normally (See page 86). 1 In the table on the next page find the 3digit number for the manufacturer of the component that you want to operate. 2 Turn on the component that you want to operate (i.e., DVD, satellite tuner, or television). 3 While holding down the MODE button on the RC-511M that you want to program, press the DISPLAY button, and then release both buttons. The SEND/LEARN indicator lights when the MODE button is pressed and turns off when the DISPLAY button is pressed. When the indicator turns off, release both buttons. The SEND/ LEARN indicator lights again. 4 Within 30 seconds, enter the 3-digit code. The SEND/LEARN indicator slowly flashes twice. If the SEND/LEARN indicator quickly flashes three times, then either a mistaken 3-digit code was entered or an incorrect operation was performed. If this occurs, return to step 3. 5 Press the button that you programmed and check if the system operates correctly. • If the component does not operate properly, return to step 3 and repeat the steps above. • If it still does not operate properly, program the command directly from the other remote controller normally (See page 86). When entering the code of Onkyo DVD players: There are three SETTING numbers. Choose the SETTING number according to how you will be using the DVD player. No. 601/613: These codes are for operating the Onkyo DVD player by pointing the remote controller directly at it, either because it does not have an terminal, or it does but you are not connecting it with an cable. First enter 601 and if it does not operate properly, enter 613. No. 600: This code is for Onkyo DVD players that have an terminal that you are connecting to the TX-NR801/TX-NR801E with an cable. You will then operate the DVD player by pointing the remote controller at the remote control sensor on the TX-NR801/TX-NR801E. You do not need to enter this code because it is factory preset. However, if the code has been changed to 601 or 613, then you will need to change it back to 600. 82