Onkyo TX SR507 Owner Manual - Page 39
Error Messages, Changing the Speaker Settings Manually, Using a Powered Subwoofer - subwoofer setup
UPC - 751398008658
View all Onkyo TX SR507 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
First Time Setup-Continued 5 When the following display appears, move the speaker setup microphone to measurement point D (page 37), and then press [ENTER]. • The right surround back speaker has been detected but the left surround back speaker hasn't. ❏ Write Error Audyssey 2EQ™ performs more measurements. This takes a few minutes. When the measurements are complete, the results are calculated and saved automatically. 6 When the room correction and speaker setup is complete, disconnect the speaker setup microphone. Notes: • When the room correction and speaker setup is complete, the Equalizer Settings (page 70) will be set to "Audyssey" and the "Dynamic EQ" (page 72) will be set to "On". • You can cancel the Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone. Error Messages While the room correction and speaker setup is in progress, one of the following error messages may appear: ❏ Ambient noise is too high This message appears if there's too much background noise and the measurements cannot be performed properly. Remove the source of the noise and try again. ❏ Speaker Detect Errors This message appears if saving fails. ❏ Mismatch Error This message appears if a speaker that was detected during the 1st measurement is not detected during the 2nd or 3rd measurements. If this message appears, check your speaker connections, and then try again. To Retry the Room Correction and Speaker Setup Press the [ENTER] button. Make sure speakers that cannot be detected are connected properly. Changing the Speaker Settings Manually If you wish to make changes to the settings found during the automatic speaker setup, follow the directions on pages 66-70. Using a Powered Subwoofer If you're using a powered subwoofer, as it outputs very low-frequency sound and its position is usually low down, it may not be detected by the Audyssey 2EQ Room Correction and Speaker Setup. In this case, increase the subwoofer's volume, select its highest crossover frequency, and then try running the Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, it may not be detected, so use an appropriate volume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct. Refer to your subwoofer's instruction manual for details. This message appears if one of the speaker-related errors below occurs. • One of the front speakers has not been detected. • One of the surround speakers has not been detected. • The surround back speakers have been detected but the surround speakers haven't. 39