Onkyo TX-SR508 Owner Manual - Page 12
Connecting the Speaker Cables, Using Banana Plugs North American models - av receiver
View all Onkyo TX-SR508 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
• Don't connect more than one cable to each speaker terminal. Doing so may damage the AV receiver. • Don't connect one speaker to several terminals. Connecting the Speaker Cables Screw-type speaker terminals Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 1/2" to 5/8" (12 to 15 mm) Using Banana Plugs (North American models) • If you are using banana plugs, tighten the speaker terminal before inserting the banana plug. • Do not insert the speaker code directly into the center hole of the speaker terminal. Push-type speaker terminals Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of 3/8" to 1/2" (10 to 12 mm) the speaker cables, and twist the bare wires tightly, as shown. The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one surround back speaker, connect it to the SURR BACK OR FRONT HIGH L terminals. Surround back Surround back right speaker left speaker Surround right Surround left speaker speaker En Front high Front high 12 right speaker left speaker Front right speaker Front left speaker Center speaker