Onkyo TX-SR508 Owner Manual - Page 40
Name Edit, Hardware, Theater-Dimensional Setting, Speaker Settings - reset
View all Onkyo TX-SR508 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Theater-Dimensional Setting ■ Listening Angle ` Wide: Select if the listening angle is 40 degrees. ` Narrow: Select if the listening angle is 20 degrees. With this setting, you can optimize the Theater-Dimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings. Front left speaker Front right speaker 20°/40° Name Edit Menu Name Edit You can enter a preset name for each individual input selector for easy identification. When entered, the preset name will appear on the display. Preparation Press the input selector buttons to select an input source. ■ Name ` - - -, Blu-ray, DVD, HD DVD, VCR, DVR, Tivo, CableSTB, SAT STB, PS3, Wii, Xbox, PC, TV, CD, TAPE, iPod: To reset to the default, select "- - -". Note • Can not set the input selector by the same name. • This menu cannot be used for the TUNER input selector. Hardware Menu Hardware Speaker Settings If you change these settings, you must run Audyssey 2EQ® Room Correction and Speaker Setup again (➔ 23). If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms. If you bi-amp the front speakers, you must change the "Speakers Type" setting. For hookup information, see "Bi-amping the Front Speakers" (➔ 13). En 40 Note • When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room. • Before you change these settings, turn down the volume. ■ Sp Impedance ` 4ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6. ` 6ohms: Select if the impedances of all speakers are between 6 and 16 ohms. Note • (North American models) Do not support speakers with an impedance of less than 6 ohms. ■ Speakers Type ` Normal: Select this if you've connected your front speakers normally. ` Bi-AMP: Select this if you've bi-amped your front speakers. ■ Front High/Zone2 ` Front High: Front high speakers can be used. ` Zone2: Zone2 speakers can be used. Select "Zone2" if you've connected your Zone 2 speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/R terminals (➔ 46). Note • If the "Speakers Type" setting is set to "Bi-AMP", this setting cannot be selected. ■ SurrBk/FrontHigh ` Front High: Front high speakers can be used. ` SurrBack: Surround back speakers can be used. Select "Front High" if you've connected your Zone 2 speakers to FRONT HIGH OR ZONE 2 SPEAKERS L/ R terminals, and the front high speakers to SURR BACK OR FRONT HIGH SPEAKERS L/R terminals. Note • If the "Front High/Zone2" setting is set to "Front High", this setting is set to "SurrBack". • If the "Speakers Type" setting is set to "Bi-AMP", this setting cannot be selected.