Onkyo TX-SR508 Owner Manual - Page 59
Recording, Zone 2, Others, Video ATT:OFF
View all Onkyo TX-SR508 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
When connecting UP-A1 Dock to the radio tuner - UP-HT1 (North American models)/UP-DT1 (European and Asian models) with AUTO selected by the tuner's Mode Selector switch, you can switch the input source between UP-A1 Dock and the tuner, by pressing PORT repeatedly on the front panel. If you still can't control your iPod, start playback by - pressing your iPod's Play button. Remote operation should then be possible. Try resetting your iPod. - Depending on your iPod, some buttons may not - work as expected. ■ The AV receiver unexpectedly selects your iPod as the input source Always pause iPod playback before selecting a dif- - ferent input source. If playback is not paused, the Direct Change function may select your iPod as the input source by mistake during the transition between tracks. Recording ■ Can't record On your recorder, make sure the correct input is - selected. When the Pure Audio listening mode is selected, - recording is not possible because no video signals are output. Select another listening mode. Zone 2 ■ There's no sound Only components connected to analog inputs can be - played in Zone 2. Others ■ The sound changes when I connect my headphones When a pair of headphones is connected, the listen- - ing mode is set to Stereo, unless it's already set to Stereo, Mono, Direct, or Pure Audio. (Pure Audio listening mode is not available for North American models.) ■ The display doesn't work The display is turned off when the Pure Audio listen- - ing mode is selected. ■ How do I change the language of a multiplex source Use the "Multiplex" setting on the "Audio Adjust" 37 menu to select "Main" or "Sub". ■ The functions and Direct Change don't work for components connected via V These functions don't work when Zone 2 is turned 17 on. ■ When performing "Audyssey 2EQ® Room Correction and Speaker Setup", the measurement fails showing the message "Ambient noise is too high.". This can be caused by any malfunction in your - speaker unit. Check if the unit produces normal sounds. ■ The following settings can be made for the composite video inputs You must use the buttons on the unit to make these settings. 1. While holding down the input selector button for the input source that you want to set, press SETUP. 2. Use F/S to change the setting. 3. Press the input selector button for the input source that you want to set when you've finished. • Video Attenuation This setting can be made for the BD/DVD, VCR/DVR, CBL/SAT, GAME, or AUX input. If you have a games console connected to the composite video input, and the picture isn't very clear, you can attenuate the gain. Video ATT:OFF: (default). Video ATT:ON: Gain is reduced by 2 dB. The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. Before disconnecting the power cord from the wall outlet, set the AV receiver to Standby. ■ The V functions don't work To use V, you must make an V connection and an 17 analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally. En 59